Operating procedures for cleaning of fully automatic horizontal molding machines for casting

Operating procedures for cleaning of fully automatic horizontal molding machines for casting:

1、 Comply with the general operating procedures of the fully automatic horizontal molding machine for casting.

2、 Before starting work, it is also necessary to comply with:

1. Check the pipeline system for any air or water leaks. If this occurs, notify the maintenance personnel for repairs.

2. Check if the cleaning solution is sufficient, and if it is not enough, add more cleaning solution in a timely manner.

3. First jog the test drive, then idle for 2-3 minutes to check the transmission system.

3、 During work, it is also necessary to comply with: imported pump valves

1. The cleaned parts should be neatly placed on the transportation belt and not pressed on the rollers;

2. On the transportation belt, the cleaned parts should not be stacked too much to avoid affecting the cleaning effect.

3. After work, the cleaned parts cannot be parked on the transportation belt.